ZoneControl

At a glance

Connects to any discrete DC voltage sensor

Single or slug accumulation

Ideal for pneumatic actuators

Daisy chain connection cable included for zone lengths of 1m (3ft) or 2m (6 ft)

Bolt-on or clip-on installation into the conveyor's side frame

Your benefits

Sensor Cable integrated for you to attach nearly any sensor

SICK's most compact ZoneControl solution, you won't even know it's there

Single or Block (slug) Accumulation Logic to maximize product throughput

The Daisy Chain means that last minute changes or adding a zone is a matter of minutes

Арт. 7028842

Features
	Dimensions (W x H x D):	31 mm x 105 mm x 74 mm
	Actuator:	Pneumatic, valve on board
	Max. number of sensors:	Ca. 30, Ca. 50 ¹⁾²⁾
	Logical principle of operation:	Single accumulation
	Type of Release:	Block (slug) release, Single release

Механика/электроника
	Supply voltage:	â‰¥ 21.6 V DC ¹⁾
	Пульсации:	2)
	Потребляемая мощность:	3)
	Output type:	PNP
	Output current Imax.:	â‰¤ 100 mA
	Тип подключения:	Cable with receptacle, M12, 4-pin, 1.1 m ⁴⁾
	Материал кабеля:	PVC
	Защита цепи:	A, C, D ⁵⁾⁶⁾⁷⁾
	Класс защиты:	III
	Материал корпуса:	ABS, Plastic
	Enclosure rating:	IP 40
	Ambient operating temperature:	-10 Â°C ... +55 Â°C
	Температура хранения:	-25 Â°C ... +75 Â°C
	Signal voltage PNP HIGH/LOW:	Approx. VS - 0.5 V / 0 V
	Connection type for daisy chain:	Cable with connector M12, 4-pin
	Medium for valves:	Compressed air or neutral gases filtered, Non-lubricated or lubricated
	Design solenoid valve:	3/2-way valve ⁸⁾
	Mode of operation solenoid valve:	Air to Drive (NC)
	Connection type solenoid valve:	Output line 4 mm diameter, Compressed air 2 x 8 mm diameter
	Coil ratings:	24 V DC 1 W
	Air flow rate:	Ca. 20 Nl/min ⁹⁾
	Ventilation capacity:	Ca. 130 Nl/min
	Operating pressure range:	2 bar ... 8 bar ¹⁰⁾

Напишите нам

⋆